How to Access Calix Router in Bridge Mode?

Calix Router generally has plenty of features like ultrafast speeds and protected browsing. But for a better experience, Calix router bridge mode is the best upgrade you can do to your device. To configure the bridge mode, follow the instructions underneath.

Generally, Calix is a renowned networking device that meets most of your networking preferences. Similarly, it has an abundance of features like ultrafast speeds and secure browsing. Additionally, Calix router bridge mode advancement is one of them that will allow you to link two networking devices to extend the network coverage at your place.

Moreover, the secondary router acts as a wireless access point and lets devices connect to the network through the primary router. In short, your secondary router turns off its network and collaborates with the primary router network to expand the network coverage. If you are looking for assistance with Calix router bridge mode setup, then stay focused on this post. You will learn the complete steps here to configure the bridge mode settings on your router.

Requirements for Calix Router Bridge Mode Setup

To put Calix router in bridge mode, get ready with a few essential pieces of equipment, such as:

How to Put Calix WiFi Router in Bridge Mode?

In addition, to configure your Calix GigaCenter Bridge mode setup, you need to set it up in WAP (Wireless Access Point) mode first. It will extend the network by accessing one primary router’s network and turning off another router’s WiFi. In short, both of your networking devices act as a single router network. To begin with this, you have to access the admin panel and then go to the Quick Start Menu and follow the instructions.

Initially, connect the computer/laptop to the existing Calix router network.
Next, open the web browser and type 192.168.1.1 IP address in the browser bar.
Now, enter the admin username and password on the Calix login window.

Further, for Calix GigaCenter Bridge Mode using EWI, visit Quick Settings>Configure Wireless Network.
Under the WAP (Wireless Access Point) or Bridge Mode section, tap on the Wireless Access Radio Point to Enable>Apply.
Hereon, Giga Centre reboots itself and works as WAP or bridge mode.
Finally, you are done with the Calix Bridge Mode process.
The same procedure is used for the Calix GigaSpire Blast Bridge mode but select Layer 2 Bridged connection type here to access it as the Bridge Mode.

Bottom-Line

On the whole, the information shared above will surely assist you in completing the Calix GigaSpire Blast Bridge mode procedure. It is necessary to follow the steps carefully to configure the bridge mode settings. After that, you can enjoy the lag-free and seamless browsing. Still, seeking more help? Drop us a line here.